Cisco CCNA 4 Chapter 2 version 6 Exam Answers

1. 1. Question

   Which three are types of LCP frames used with PPP? (Choose three.)

   •  link-negotiation frames
   •  link-acknowledgment frames
   •  link-maintenance frames
   •  link-termination frames
   •  link-control frames
   •  link-establishment frames

2. 2. Question

   Which command can be used to view the cable type that is attached to a serial interface?

   •  Router(config)# show interfaces
   •  Router(config)# show controllers
   •  Router(config)# show ip interface
   •  Router(config)# show ip interface brief

3. 3. Question

   How does PPP interface with different network layer protocols?

   •  by using separate NCPs
   •  by negotiating with the network layer handler
   •  by encoding the information field in the PPP frame
   •  by specifying the protocol during link establishment through LCP

4. 4. Question

   Which address is used in the Address field of a PPP frame?

   •  a single byte of binary 00000000
   •  a single byte of binary 10101010
   •  a single byte of binary 11111111
   •  the IP address of the serial interface

5. 5. Question

   Which field marks the beginning and end of an HDLC frame?

   •  Data
   •  FCS
   •  Control
   •  Flag

6. 6. Question

   In which situation would the use of PAP be preferable to the use of CHAP?

   •  when router resources are limited
   •  when multilink PPP is used
   •  when plain text passwords are needed to simulate login at the remote host
   •  when a network administrator prefers it because of ease of configuration

7. 7. Question

   When configuring Multilink PPP, where is the IP address for the multilink bundle configured?

   •  on a physical serial interface
   •  on a subinterface
   •  on a multilink interface
   •  on a physical Ethernet interface

8. 8. Question

   Refer to the exhibit. Based on the debug command output that is shown, which statement is true of the operation of PPP.

   

   CCNA4 v6.0 Chapter 2 Exam 003

   •  CHAP authentication failed because of an unknown hostname.
   •  A PPP session was successfully established.
   •  Both PAP and CHAP authentication were attempted.
   •  The debug output is from router R2.

9. 9. Question

   Refer to the exhibit. A network administrator is configuring the PPP link between the two routers. However, the PPP link cannot be established. Based on the partial output of the show running-config command, what is the cause of the problem?​

   

   CCNA4 v6.0 Chapter 2 Exam 002

   •  The usernames do not match.
   •  The passwords do not match.
   •  The passwords should be longer than 8 characters.
   •  The interface IP addresses are in different subnets.

10. 10. Question

    Which is an advantage of using PPP on a serial link instead of HDLC?

    •  option for authentication
    •  higher speed transmission
    •  fixed-size frames
    •  option for session establishment

11. 11. Question

    Which protocol will terminate the PPP link after the exchange of data is complete?

    •  NCP
    •  LCP
    •  IPCP
    •  IPXCP

12. 12. Question

    Which serial 0/0/0 interface state will be shown if no serial cable is attached to the router, but everything else has been correctly configured and turned on?

    •  Serial 0/0/0 is up, line protocol is up
    •  Serial 0/0/0 is up, line protocol is down
    •  Serial 0/0/0 is down, line protocol is down
    •  Serial 0/0/0 is up (looped)
    •  Serial 0/0/0 is up (disabled)
    •  Serial 0/0/0 is administratively down, line protocol is down

13. 13. Question

    How much total bandwidth is provided by a T1 line?

    •  1.544 Mb/s
    •  64 kb/s
    •  128 b/s
    •  43.736 Mb/s

14. 14. Question

    A network engineer is monitoring an essential, but poor quality, PPP WAN link that periodically shuts down. An examination of the interface configurations shows that the ppp quality 90 command has been issued. What action could the engineer take to reduce the frequency with which the link shuts down?

    •  Issue the command ppp quality 70.
    •  Issue the command ppp quality 100.
    •  Set the DCE interface to a lower clock rate.
    •  Use the bandwidth command to increase the bandwidth of the link.

15. 15. Question

    A network engineer is troubleshooting the loss of MPEG video viewing quality as MPEG video files cross a PPP WAN link. What could be causing this loss of quality?

    •  PAP authentication was misconfigured on the link interfaces.
    •  The clock rates configured on each serial interface do not match.
    •  Link Quality Monitoring was not configured correctly on each interface.
    •  The compress command was used when PPP was configured on the interfaces.

16. 16. Question

    Which PPP option can detect links that are in a looped-back condition?

    •  Magic Number
    •  MRU
    •  Callback
    •  ACCM

17. 17. Question

    A network engineer has issued the show interfaces serial 0/0/0 command on a router to examine the open NCPs on a PPP link to another router. The command output displays that the encapsulation is PPP and that the LCP is open. However, the IPV6CP NCP is not shown as open. What does the engineer need to configure to open the IPV6CP NCP on the link?

    •  Configure CHAP authentication on each router.
    •  Configure PPP multilink interfaces on each router.
    •  Configure an IPv6 address on each interface on the link.
    •  Issue the compress predictor command on each interface on the link.

18. 18. Question

    Which three physical layer interfaces support PPP? (Choose three.)

    •  FastEthernet
    •  GigabitEthernet
    •  Ethernet
    •  Ethernet
    •  synchronous serial
    •  HSSI

19. 19. Question

    What are three components of PPP? (Choose three.)

    •  authorization
    •  LCP
    •  parallel communications
    •  NCP
    •  support for LAN and WAN
    •  HDLC-like framing

20. 20. Question

    Refer to the exhibit. What type of Layer 2 encapsulation will be used for connection D on the basis of this configuration on a newly installed router:

    RtrA(config)# interface serial0/0/0 
    RtrA(config-if)# ip address 128.107.0.2 255.255.255.252 
    RtrA(config-if)# no shutdown

    

    CCNA4 v6.0 Chapter 2 Exam 001

    •  Ethernet
    •  Frame Relay
    •  HDLC
    •  PPP

21. 21. Question

    Which two statements describe a PPP connection between two Cisco routers? (Choose two.)

    •  LCP tests the quality of the link.
    •  LCP manages compression on the link.
    •  Only a single NCP is allowed between the two routers.
    •  NCP terminates the link when data exchange is complete.
    •  With CHAP authentication, the routers exchange plain text passwords.

22. 22. Question

    Match the PPP options with the correct description. (Not all options are used.)

    
    

    CCNA4 v6.0 Chapter 2 Exam 01

23. 23. Question

    Match the phases of establishing a PPP session in the correct order. (Not all options are used.)

    
    

    CCNA4 v6.0 Chapter 2 Exam 02

24. 24. Question

    Match the steps to the PPP CHAP authentication process sequence. (Not all options are used.)

    
    

    CCNA4 v6.0 Chapter 2 Exam 03